Intro:
MacBook ka clutch cover screen aur base ke beech ka ek protective part hota hai. Agar yeh loose ho gaya hai, toot gaya hai ya scratch ho gaya hai, toh usse replace karna easy hai — bas kuch tools aur thoda patience chahiye.

🧰 Tools Needed:

  • Phillips #00 Screwdriver

  • T6 Torx Screwdriver

  • Spudger

  • Tweezers (optional)

⚠️ Important Safety Note:

  • MacBook ko shutdown karo aur unplug karo.

  • Battery disconnect karna zaroori hai taaki kisi tarah ka short circuit na ho.

  • Anti-static surface pe kaam karo, ya anti-static wrist strap use karo.

📋 Step-by-Step Instructions:

Step 1: Bottom Case Remove Karo

  • MacBook ko ulta rakho.

  • Neeche ke 10 screws ko Phillips #00 screwdriver se nikaalo.
    (Dhyan se dekho – kuch screws lambe hote hain, unhe alag rakh lo.)

  • Lower case ko gently upar uthao aur side mein rakh do.

Step 2: Battery Disconnect Karo

  • Spudger se battery connector ko gently unplug karo.

  • Ye step skip mat karna — yeh sabse important safety step hai.

Step 3: Camera Cable Disconnect Karo

  • Camera cable ko logic board se gently unplug karo.

  • Cable ko sidha kheecho — twist mat karo, warna damage ho sakta hai.

Step 4: Display Assembly Remove Karo

  • Hinges ke screws (T6 Torx) nikaalo.

  • Screen (display assembly) ko carefully base se alag karo.

  • Is step ke baad aapko clutch cover tak full access mil jaayega.

Step 5: Clutch Cover Remove Karo

  • Clutch cover ko gently pull karo.

  • Agar tight ho, to spudger ki help se halka sa lift karo.

  • Don’t use too much force — yeh plastic part hai, toot sakta hai.

Step 6: Naya Clutch Cover Install Karo

  • New clutch cover ko same position mein align karo.

  • Usse gently press karke fit karo, taaki click sound aaye ya snug fit ho.

Step 7: Display Wapas Lagao

  • Screen ko waapas base se align karo.

  • T6 screws se hinges secure karo.

  • Camera cable ko logic board se connect karo.

  • Battery connector ko fir se plug karo.

Step 8: Bottom Case Close Karo

  • Lower case ko wapas lagao.

  • 10 screws ko unke original jagah pe tighten karo using Phillips screwdriver.

✅ Final Check:

  • MacBook on karo aur screen ka alignment check karo.

  • Display open/close smooth ho raha hai ya nahi dekh lo.

  • Agar sab theek hai, to clutch cover replacement successful hai!

💡 Helpful Tip:

  • Purani clutch cover ko sambhal ke rakh lo jab tak new one properly work kare.

  • Screws ko misplace mat karo — alag se label karke rakhna best hota hai.

Scroll to Top