Intro:
Agar aapka MacBook ka trackpad kaam nahi kar raha, click nahi ho raha, ya touch response sahi nahi hai, toh yeh guide aapko trackpad ko replace karne mein madad karegi.

🧰 Tools You’ll Need

  • Phillips #00 screwdriver

  • Tri-point Y0 screwdriver

  • Spudger ya plastic pry tool

⚠️ Safety Tips

  • MacBook ko shutdown karo aur charger unplug kar do.

  • Anti‑static surface pe kaam karo.

  • Battery connector ko disconnect karna zaroori hai taaki electrical discharge na ho.

📋 Step-by-Step Instructions

Step 1: Lower Case Screws Remove Karo

  • MacBook ko ulta rakho.

  • 10 screws remove karo:

    • 7 screws (3 mm Phillips)

    • 3 screws (13.5 mm Phillips)

Step 2: Lower Case Ko Lift Karo

  • Thoda lift karo lower case ko aur peeche ki taraf slide karo taaki mounting tabs free ho jaayen.

  • Phir poori case ko hata lo.

Step 3: Battery Screws Remove Karo

  • Battery ko upper case se secure kar rahe 2 tri-point screws remove karo:

    • 1 screw (5.5 mm)

    • 1 screw (13.5 mm)

Step 4: Battery Connector Ko Disconnect Karo

  • Spudger ka flat end use karo battery connector ko gently lift kar ke logic board se disconnect karo.

Step 5: Battery Ko Remove Karo

  • Battery ko gently lift kar ke upper case se nikaal lo.

Step 6: Trackpad Connector Ko Disconnect Karo

  • Spudger ka flat end use karo trackpad connector ko gently lift kar ke logic board se disconnect karo.

Step 7: Trackpad Ko Lift Karo

  • MacBook ko open karo aur table par rakh do.

  • Trackpad ke edge ko gently lift karo taaki wo upper case se free ho jaaye.

Step 8: Trackpad Screws Remove Karo

  • Trackpad ko upper case se secure kar rahe 4 screws remove karo:

    • 1.2 mm Phillips screws

Step 9: Trackpad Ko Remove Karo

  • Trackpad ko gently lift kar ke upper case se nikaal lo.

✅ Reassembly

Sab steps ko ulta karte hue:

  • Naya trackpad install karo

  • Screws, connectors — sab theek se lagao

  • Battery connector ko wapas connect karo

  • Lower case ko wapas laga ke screws tight karo

Scroll to Top