Intro:
Agar aapka MacBook Wi-Fi connect nahi kar raha ya signal weak aa raha hai, toh problem AirPort card mein ho sakti hai. Is guide mein hum aapko batayenge ki kaise aap khud MacBook ka AirPort card replace kar sakte ho.

🧰 Tools Required:

  • Phillips #00 Screwdriver – screws kholne ke liye

  • Spudger – cables gently nikaalne ke liye

  • T6 Torx Screwdriver – AirPort card ke screws ke liye

⚠️ Dhyaan De:

  • MacBook shutdown karo aur power unplug kar do.

  • Battery disconnect karna bahut zaroori hai — safety ke liye.

  • Anti-static surface par kaam karo ya ESD strap pehno.

📋 Step-by-Step Instructions:

Step 1: Bottom Case Remove Karo

  • MacBook ko ulta rakho.

  • 10 screws ko Phillips #00 screwdriver se nikaalo.
    (Kuch screws chhote hote hain, unko alag rakhna mat bhoolna.)

  • Lower case ko upar lift karo — halka force lagana padega.

Step 2: Battery Ko Disconnect Karo

  • Battery connector ko spudger ki help se gently disconnect karo.

  • Is step ko skip mat karna — MacBook ke internal parts ko damage ho sakta hai.

Step 3: Camera Cable Disconnect Karo

  • Camera cable ko logic board se remove karo.

  • Cable ko seedha kheecho — twist ya zyada force mat lagao.

Step 4: AirPort Card Screws Remove Karo

  • AirPort card pe lage do T6 Torx screws ko nikaalo.

  • Screws ke baad card gently lift karo.

  • Antenna wires ko carefully unplug karo — note kar lo ki kaunsa wire kahaan laga tha.

Step 5: New AirPort Card Install Karo

  • Naya AirPort card same position mein install karo.

  • Antenna wires ko sahi order mein wapas connect karo.

  • Screws wapas lagao taaki card secure ho jaye.

Step 6: Camera Cable & Battery Wapas Jodo

  • Camera cable ko logic board se fir se connect karo.

  • Battery connector ko bhi wapas jod do.

Step 7: Bottom Case Lagao

  • Lower case ko place karo aur 10 screws wapas tight karo.

✅ Final Test:

  • MacBook on karo.

  • Wi-Fi settings mein jaake dekho kya Wi-Fi network detect ho raha hai.

  • Agar sab kuch sahi hai, to replacement successful hai!

💡 Helpful Tip:

  • Screws aur small parts ko ek tray ya labeled box mein rakho.

  • Photo le lo har step ka, taaki wapas lagate waqt confusion na ho.

Scroll to Top